Dedicated Circuits for Shops and Garages
Sized to the machine that will actually be plugged in.
One Circuit, One Load, Sized Correctly
A dedicated circuit is a home run for a single load: a welder, a compressor, a kiln, a shop tool, a detached garage, an outbuilding. The wire, the breaker, and the receptacle are chosen for that machine — not borrowed from the nearest bedroom circuit.
Equipment loads are everyday work here. Detached garages and outbuildings get a properly sized circuit rather than an extension cord run through a door frame, and if the panel is already near its limit, you hear that before the circuit is sold.
When capacity is the real problem, we quote the service upgrade beside the new circuit so the number is honest — see panel upgrades instead of adding one more tandem breaker to a service that has no room left.
What We Run
- 240-volt circuits for welders, compressors, kilns, and shop equipment, matched to the nameplate on the machine.
- Circuits for detached garages and outbuildings, so the building has its own supply instead of an extension cord.
- Load checks before the quote, so a new circuit does not start tripping the rest of the house the first time everything runs at once.
- Dedicated runs for a specific appliance that keeps nuisance-tripping a shared circuit.
- A referral to EV charger installation when the load is a car, because that circuit has its own requirements.
If the machine needs more than the service can deliver, adding a circuit is the wrong first purchase. We tell you that on the estimate, not after the install.
Common Questions
Can you add a circuit for a welder or a compressor?
Yes. The circuit is sized to the machine that will be plugged into it, and we check that the panel can carry it before it is installed.
What about a detached garage or an outbuilding?
It gets its own properly sized circuit. An extension cord is not the install, and it is not something we will leave you with.
What if my panel is already full?
Then you hear that before the work is sold. Sometimes there is room for one more breaker and sometimes the honest answer is a service upgrade, and either way the number comes to you before the job.